User manual

4
NX8000 Card
2.3 Connecting the Watchdog line on NX8000 series
Connecting the NX8000 to the motherboard reset switch panel, enables the unit to restart
automatically and reset the system when an error has been detected.
1. Look for the labeled RESET SW switch lead and connect it to the NX8000 card reset pin.
2. Connect the supplied Watchdog line to the NX8000 card watchdog pin and the other end to the
motherboard RESET SW panel. If you are not sure, please refer to the motherboard user manual.
3. You may now replace back the PC cover and connect all the cables.
R
eset SW lead
Wat ch dog l i n e
NX8000