User manual

97
To and CC: Enter the recipient email address and separate it with comma or a semicolon (;).
Subject: Enter the message title.
Message: Type the message.
(3) Email Notice Setting
Notice Interval: Set the period of time before it sends another e-mail notice.
Embedded image : Select the image size and set the number of frames.
Attach image when sensor is triggered: When the sensor is triggered, the system will capture
the image and send the image to the certain e-mail address with the alarm message.
(4) Modem Dial up Setting
If you are using dial up modem, enable Auto Dial up check box and select the modem name. You
may also set the time to disconnect automatically, just enable the Auto Disconnect after check
box and set time.
5.9.5 To Setup FTP Setting:
1. Beside the File Transmission via FTP check box, click
Detail.
2. In the FTP Setting dialog box, enter the FTP IP, port,
user ID and password.
3. In Number of Pic text box, enter the number of
sequence images that want to send when file is
transmitting. The maximum number of picture can be
transmitted are 16.
4. In Upload image when sensor is triggered, select
the camera that the images will be capture and send
when the sensor is triggered.
5. Click OK to exit and save the setting and Cancel to exit without saving the setting.
5.9.6 To Setup Alarm Recording Setting:
1. Beside the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select the
camera to enable/disable video recording. Enable All
to select all cameras.
3. In the Frame Rate selection, select As Setting to
record the number of frames based on the Recording
Setting or Max to record the maximum of frames
based on the available speed (maximum is 32
pictures)
4. In the Start Recording prior text box, mark and set
the number in second for the program to pre-recording before the alarm happen. The time range
is 1~600 seconds..
5. In the Stop Recording after text box, mark and set the number in second for the program to
continue recording after the alarm has ended. The time range is 1~600 seconds. If user doesn’t
mark and set the time, the alarm recording will continue recording until alarm is reset.
6. Click OK to accept the new settings and Cancel to exit without saving.