User manual

94
- Start Recording
Record the video from the selected camera. To setup click Detail (see also Chapter 5.9.6
).
- SMS (Short Message Service)/MMS (Multimedia Messaging System)
SMS transmits only text messages to mobile phone. MMS transmits text messages and
images over wireless networks using the wireless application protocol (WAP). Make sure your
mobile phone support this feature and your PC is connected to GSM/GPRS modem. To setup
click Detail (see also Chapter 5.9.7
).
- PTZ preset point
Position the PTZ camera based on the preset point setting. To setup click Detail (see also
Chapter 5.9.8
).
- Alarm SOP (Standard Operation Procedure)
List the instructions to inform the person of what to do when the alarm is activated. To setup
click Detail (see also Chapter 5.9.9
).
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video to CMS when the alarm is activated (see
also Chapter 5.9.10
)
- Launch Program
To call up the external program that is provided by 3
rd
party. Click
Detail
and click to
locate the program path. Enable
Multiple instance
check box to allow the program can be
executed multiple times at the same time.
- Snapshot
Take a snapshot when the alarm is activated.
a. Select Camera: specify which channel video to be snapshot when the alarm is occurred.
- Alarm Camera: when a channel has an alarm occurred, and then, the DVR system
will snapshot the channel video.
- Camera # (1~32): the selected channel would be snapshot when an alarm is occurred.
b. Video Size: select the size of snapshot picture.
c. Number of picture: the number of picture that is going to be taken.
d. Snapshot Interval: a time gap for next snapshot
e. Save Path: a storage path for saving snapshot pictures.
f. Delete image after: set a storage limit of snapshot image. When the snapshot image is
over the limit, and then, the system will start recycle the snapshot image.