User manual

34
You can only use this function when the Auto Brightness Control is enabled.
(8) Enable Deinterlace
To enhance the video quality. Set the de-interlace mode to #1, if you are capturing motionless picture
and #2, if it captures lots of movement.
i
De-interlace doesn’t support on EB DVR series.
3.4.2.3 Record Setting
Click OK to accept the new settings, click Exit to exit without saving, and click Default to revert back
to original factory setting.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras, enable the
ALL check box. To select more than one camera, Right click on the camera icon. To select one
camera only, Left click on the camera icon. The camera icon turns red when it is selected.
(2) Recording Mode
The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select the
recording mode and click the ~ button. If you want to only record at a particular time or day, click
Schedule button and select the Recording Mode , and then click on the time or day blocks. When the
system starts recording a red triangle mark would appear at the upper left corner of the screen.
The recording modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path
- Motion Recording
Start recording the video from the selected camera only when the system detects movement.
Once a motion is detected, the system automatically saves the previous frames and stop based
on the Start Record Prior and Stop Record After settings.
- Smart Recording