User manual

AVerTV 6
30
4.3.3 Editing or Removing Frequencies
You can edit or delete the undesired frequencies if the data is incorrect.
1. Click the Setup button
and in the Setup dialog box, click the Digital TV icon on
the left pane.
2. Click Edit next to the satellite name where you want to edit frequencies. The Satellite
Information dialog box will appear.
3. Then choose one of the following actions:
To edit a single
frequency
Select the desired frequency. Change its data, such as its
frequency or FEC, and then click Modify.
To delete a single
frequency
Select the frequency that you want to remove, and click the
Remove button located on the lower-left corner.
To delete the whole
frequency table
Click the Remove button located on the upper-right corner.
4. Click OK to exit the dialog box.
4.3.4 Scanning Single or Range Frequency (For Advanced Users)
1. Select the desired program name from the Program List.
2. Click Advance located at right-lower corner in the
Programs Information section. Then the Advance dialog box will appear.
3. When there are programs/frequencies missing from the program list, select Single
Frequency or Range Frequency.
Note: Range Frequency may take you from several hours to more than a half day. Please be
patient.
4. Specify the correct input port, polarization, frequency and symbol rate.
5. Click Scan.
6. After scanning, new active programs/frequencies will be memorized and listed on the
left pane of the dialog box.
7. Click OK to save the scanned results.
8. Click Apply to save the scanned channel.