User manual

32
3.4 Network Setup
Click Default will back to the factory default value.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(1) Server Name
Assign a name for the DVR unit. Alphabet letters and numbers only.
(2) Transmitting Cameras
Select and click on the camera number in the Transmitting Camera section you want to make it
accessible via internet using WebViewer, Remote Console, CM3000(Gold),PDA Viewer and JAVAViewer
(still image). To select all the cameras, enable the ALL check box.
(3) Main Configuration
Set the DVR IP address and Remote Console Port. You need this when accessing DVR server from the
remote location via internet.
The DVR system supports dual LANs; therefore, user can select the Server IP from the drop-down list
and click Setting to configure the detail. The dual LAN ports can balance network bandwidth to avoid the
network traffic congestion.
i
- The default IP of the DVR server is 192.168.2.2 for LAN1 (lower LAN port in the back of the DVR) and
192.168.3.2 for LAN2 (upper LAN port in the back of the DVR).
- LAN1 can be set as Static or DHCP mode and only for LAN connection.
- LAN2 can be set as Static, DHCP, or PPOE mode and for both WAN and LAN connection.
When only using port LAN2, please set IP address of port LAN 1 in different LAN segment from port LAN 2.