User manual

28
OSD MENU Description
123 4
0080
5005
NETWORK SETUP
IP MODE
NW ENABLE
VIDEO PORT
UPGARDE PORT
PPPOE

PPPOE:
Point-to-Point Protocol over Ethernet is a network
protocol for encapsulating PPP frames in Ethernet frames.
It is used mainly with ADSL services. If your network is
using ADSL service connecting to internet, and then, select
PPPOE mode. Use
▲
and
▼
buttons to go up and
down and select
PPPOE
, and then press
or
▼
to
make selection. A message window will show up as below:
GE T IP NOW! WAITING...
When DVR system get an IP address, the information will
display as below:
192.168.153.254
192.168.153.1
00.00.00.00.00.00
NETWOR K INFOR MATION
IP ADDRESS
SUB NET
GATEWAY
DNS
MAC ADDR E SS
CHANGE
192.168.153.100
255.255.255.255
NW ENABLE
Allow internet remote user to playback or monitor the channels.
Without enabling the network function, the channels cannot be
playback or monitor from remote site.
i
F 1 is Channel 1 F 2 is Channel 2
F 3 is Channel 3 F 4 is Channel 4
Use
▲
and
▼
buttons to go up and down and select
NW ENABLE
(network enable), and then press
or
▼
and
▼
to move to the selection
. Use
▲
and
▼
buttons
to change the selections values and press
or
▼
to
confirm.
VIDEO PORT
A port for the remote connection. Any port can be assigned as a
video port, except the ports already used by the network
services. The default video port is 80.
Use
▲
and
▼
buttons to go up and down and select
VIDEO PORT
, and then press
or
▼
and
▼
to move
to the selection
. Use
▲
and
▼
buttons to change the
selections values and press
or
▼
to confirm.