User manual

29
-
IP:
Assign a constant IP address which a real IP address gives from ISP to DVR system.
-
Mask:
It is a bitmask used to identify the sub network and how many bits provide room for host
addresses. Enter the subnet mask of the IP address which user has assigned to DVR system.
-
Gateway:
A network device acts as a passageway to internet. Enter the network gateway IP
address
-
DNS:
Domain Name Server translates domain names (such as www.abb.com.tw) to IP addresses.
Enter the IP address of DNS if it is available.
-
MAC Address:
An identifier hardware address of DVR unit that is assigned by the manufacturer
for identification. User don’t need to fill in, it will generated by system automatically.

Obtain an IP automatically (DHCP):
Assign the IP address by local DHCP server to DVR system.

PPPOE:
Point-to-Point Protocol over Ethernet is a network protocol for encapsulating PPP frames in
Ethernet frames. It is used mainly with ADSL services. If your network is using ADSL service
connecting to internet, and then, select PPPOE mode. Enter
User ID
and
Password
that is given by
your ISP for PPPOE connecting authority.

DDNS:
DDNS(Dynamic Domain Name Service) is a data query service mainly used on the Internet
for translating domain names into Internet addresses. Users can register their own domain name on
http://ddns.avers.com.tw
. (See Appendix A
)
-
Domain Name
Enter the domain name that user has registered.
-
Password
A password use to access DDNS that user has setup when register the domain name
-
DDNS Server Name
Select your DDNS server. The default only has one DDNS server now. It may provide more DDNS
in future.
-
DDNS Server Port
Fill in the port that connects to DDNS server. Default is 1053.
(4) Remote Upgrade Configuration
A port is using for the remote firmware upgrade through network.
(5) WebViewer Configuration
Activate Enable Anonymous Login to remotely access the DVR server without the need of password.
Fill in the WebViewer PORT for remote accessing connection.
(6) Network Time Synchronization
Adjust the DVR system time same as network time server. Fill in the Time Server IP address or domain
name and select the Time Zone. User can enable Automatic Synchronize at to set automatic
synchronize time on a daily basis. Or, user can click Synchronize Time Right Now to adjust time right
away.
(7) Other Configuration
- Enable White List
An access permit list for the remote accessing of DVR server. Enter the IP address and click Add.
Or, enter a range of IP address and click Add. To delete the IP from the list, select the IP and click
Delete button. To reset the input, click Clear button.