User manual

14
2.2.2 Familiarizing the Buttons in PTZ Camera Controller
(1)
(11)
(2)(3)(4)(5)
(6)
(7)
(8) (9) (10)
Name Function
(1) Close Exit PTZ camera controller.
(2) Setup Configure PTZ cameras.(see also Chapter 2.2.2.1)
(3) AutoPan
Operate the PTZ cameras automatically based on the selected camera group preset
position number.
(4) Focus +/- Adjust the focus manually to produce clear image.
(5) Zoom +/- Zoom in and out the image.
(6) Direction buttons Adjust and position the focal point of the PTZ camera.
(7) Camera ID pane Display the PTZ camera number that is being operated.
(8) Save Camera
preset position
Save the PTZ camera preset position number. Select the camera and click the preset
position number and save it.
(9) Camera lens
speed controller
Adjust the moving speed of the PTZ camera lens.
(10) Camera preset
position number
Move the PTZ camera to the preset point.
(11) Group AutoPan Select to automatically operate PTZ camera in group.
2.2.2.1 Setup the IP PTZ Camera
When IP PTZ camera has successful connected with the DVR system, user can use the PTZ function
directly without any configuration. To make connection of IP PTZ camera, please refer to Chapter 3.2.1
.
In PTZ camera panel, user can setup the preset position of the camera. The number of preset positions
are depend on the IP PTZ camera that user has connected. For example: A brand of IP PTZ camera only
supports 4 preset positions. Therefore, user only can setup 4 preset positions on the DVR system. User
can refer to the user’s manual of the IP PTZ camera to make sure the number of the preset positions has
supported.
Please follow the below steps to configure the preset position.
1. On Preview UI, select the channel that is an IP PTZ camera connection.
2. Click PTZ button from Preview UI and PTZ control panel will show up.
3. In the PTZ control panel, using the arrow button to adjust the position of IP PTZ camera.
4. And then, click Setup (see also Chapter 2.2.2). The Preset Settings window will show.