User manual

9
Chapter 2 Operating the DVR unit
2.1 First Time Using the DVR Unit
1. Connect the mouse to the USB port located at front panel of the DVR unit.
2. Using the mouse and virtual keyboard (see also Chapter 2.1.1
) to operate the DVR system.
3. Power on the DVR unit.
4. For security purpose, the DVR system would require you to enter User ID and Password before it can
be accessed. (If this is the first time, enter the default ID [
superuser
] and password [
111111
]).
Preview UI
5. Formatting the hard disk.
a. Click
Setup
and enter the password
b. Click
System
→
Add
c. Select the hard disk from device list and select
Format type
d. Click
Format
button to start formatting
e. When formatting is done, click
OK
.
6. Setup the date and time in order to have correct recording time and date.
a. Click
Setup
and enter the password
b. In
Time
section, click
Setting
button of
System Time
.
c. Select the date and adjust the time, and then, click
OK
.
7. Connect the IP camera.
a. Click
Setup
→
Camera
b. Select camera channel and type of camera – IP Camera
c. And then, enable the camera
d. Click
IP Setting
e. Enable
Protocol
, and then, select
protocol
,
mode
,
video format
, and
channel
of IP camera.
f. Enter
IP address
or
URL
of IP camera.
g. Enter
ID
and
password
if IP camera’s access authority is required.
h. Click
OK
.
a. To connect another IP camera, follow the above steps.