User manual

39
Automatically switch to recorded at the maximum frame rate setting once a motion is detected
and if there is no motion, it records at the minimum frame rate setting.
- No Recording
The system won’t do any recording.
(3) Motion Detection
Adjust the sensitivity of the motion detection. The higher the value, the finer the sensitivity is
detected. When it detects a motion, a green triangle mark would appear at the upper left corner of
the screen.
3.3.2 Setup Analog Camera Record Setting
Click Default will back to the factory default value.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras, enable
the ALL check box. To select more than one camera, Right click on the camera icon. To select one
camera only, Left click on the camera icon. The camera icon turns purple when it is selected.
(2) Recording Mode
The horizontal blocks from 00 to 23 represent the time in 24-hour clock and the vertical block 1 to 7
represent the day in the week block (Sunday to Saturday). To record in full 24 hours and 7 days a
week, select the recording mode and click the ~ button. If you want to only record at a particular
time or day, click Schedule button and select the Recording Mode , and then click on the time or
day blocks. When the system starts recording a red triangle mark would appear at the upper left
corner of the screen. The recording modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage device
- Motion Recording
Start recording the video from the selected camera only when the system detects movement.