User manual

18
c. Select the hard disk from device list and select
Format type
d. Click
Format
button to start formatting
e. When formatting is done, click
OK
.
5. Setup the date and time in order to have correct recording time and date. Following the below
steps to setup date and time:
a. Click
Setup
and enter the password
b. In
Time
section, click
Setting
button of
System Time
.
c. Select the date and adjust the time, and then, click
OK
.
6. Following the below steps to connect the IP and analog camera.
To connect analog camera:
a. Plug the analog camera video cable into DVR video port.
b. Click
Setup
→
Camera
c. Select camera channel and type of camera – Analog Camera
d. And then, enable the camera
e. Give a name of camera and enter short description.
f. Adjust the bright, contrast, hue, and saturation of camera
g. Click
OK
To connect IP camera:
a. Click
Setup
→
Camera
b. Select camera channel and type of camera – IP Camera
c. And then, enable the camera
d. Click
IP Setting
e. Enable
Protocol
, and then, select
protocol
,
mode
,
video format
, and
channel
of IP
camera.
f. Enter
IP address
or
URL
of IP camera.
g. Enter
ID
and
password
if IP camera’s access authority is required.
h. Click
OK
.
i. To connect another IP camera, follow the above steps.
i
– DVR unit can connect 16 cameras in analog and IP cameras combo.
– DVR unit doesn’t supply the power to connected external device.
2.1.2 Using the Virtual Keyboard
User can use the Virtual Keyboard when the keyboard is not available. Just click or right-click
screen to call out the virtual keyboard. For uppercase, click
Caps
button. To exit, click
Esc
.