Specifications

36
(5) Auto Record
Enable/disable auto continue recording when interrupted (i.e., power breakdown, video
playback or configuration setup). It continue recording after 10 second of idleness. This
is applicable in Always Record mode under schedule setting.
(6) Audio Record
Enable/disable audio recording. To record sound, make sure the microphone is
connected to the unit
(7) Disk Overwrite Enable
Enable/disable replacing the earliest record when the hard disk space runs out. By
default, the HDD overwrite setting is enabled
(8) Motion Detection
- Motion Camera
Enable/disable the channel number to detect motion.
- Motion Record Time
Set the amount of time (in second) to record when a motion has detected.
- Sensitivity
Set the sensitivity level. The sensitivity is from high, 9~ 2 and low.
8.1.1.3 Alarm/Sensor Setup
(1)
(2)
(3)
(1) Alarm Setup
- Mail Alarm Enable
Enable/disable alarm sending mail when alarm has triggered or motion has detected.
i
The Motion Detection must be enabled first, the alarm sending mail will send out
the mail when detect motion.
- Alarm Out Time
Set the amount of time (in second) to continue sending the alarm once activated
(2) Sensor Setup
- Sensor Status
Customize the initial state of the attached sensor for every camera. Refer to the table