Specifications

18
OSD MENU Description
010 SEC
010 SEC
NOT INSTALLED
NOT INSTALLED
NOT INSTALLED
NOT INSTALLED
SENSOR SETUP
SENSOR REC TIME
ALARM OUT TIME
CHANNEL - 1
CHANNEL - 2
CHANNEL - 3
CHANNEL - 4
SENSOR REC TIME :
Set the amount of time (in second) to start record when the
sensor has triggered
ALARM OUT TIME :
Set the amount of time (in second) to continue sending the alarm
once triggered
CHANNEL 1~4 :
Customize the initial state of the attached sensor. Refer to the
table below to customize the sensor state
Condition Description
NOT INSTALLED Indicates that there is no sensor connected
NORMAL OPEN Indicates that the initial state of the sensor is
normal open. Video recording initiates when
there is a changes in the sensor state
NORMAL CLOSE Indicates that the initial state of the sensor is
normal close. Video recording initiates when
there is a changes in the sensor state
1 2 3 4
L
010 SEC
M
O
T
I
O
N
SE
T
U
P
MOTION CAMERA
SENSITIVITIY
MOTION RECORD TIME
MOTION CAMERA :
Enable/disable the channel number to detect motion.
SENSITIVITY :
Set the sensitivity level. The sensitivity is from H (High), 9~ 2 and
L (Low).
MOTION RECORD TIME :
Set the amount of time (in second) to record when motion is
detected.
1 2 3 4
80
5005
NETWORK SETU
P
IP MODE
NW ENABLE
VIDEO PORT
UPGARDE PORT
STATIC
NETWORK SETUP:
Setup the network parameters for the internet or intranet remote
monitor or playback.
IP MODE:
The system provides 3 types of IP setup mode – Static, DHCP,
and PPPOE.
Use and buttons to go up and down and select
IP
MODE
, and then press . Use and buttons to
change the selections and press
or to make a
selection.

STATIC:
Assigns a constant IP address for the DVR system.
Use and buttons to go up and down and select
items, and then press or to make selection. Use
and to move left and right to select or enter the
configuration value.
-
IP ADDRESS:
Assign a constant IP address which a real
IP addresses give from ISP to DVR system.
-
SUBNET:
It is a bitmask used to identify the sub network
and how many bits provide room for host addresses. Enter
the subnet mask of the IP address which user has
assigned to DVR system.