Specifications

10
2.3 Surveillance Screen
To know if the channel is being recorded, the “” record symbol would appear beside the
channel number. The (microphone) and (speaker) indicate that the audio is available.
The information below the screen shows the current date and time, recording mode (record
schedule setting), and the percentage of the used hard disk space.
D1 (A) HDD 29%
D1 mode Screen Preview
CIF(A) HDD 29%
CIF model Preview
When you are in full screen preview, press the following buttons on the remote control to
switch to different channel, or preview all 4 channels:
1
CH1: Camera1
3
CH2: Camera 2
7
CH3: Camera 3
9
CH4: Camera 4
5
QUAD: 4-Channel
2.4 Playback the Video
The DVR system can record and playback video simultaneously. Therefore, user don’t
need to stop recording while playback the video.
1. Press
2. Use the and buttons to go up and down
and select TIME SEARCH or EVENT LIST. Then, press
or to make a selection.
SEARCH METHOD
TIME SEARCH
EVENT LIST

TIME SEARCH (search by date and time):
1. Use the and buttons and select
SEARCH
TIME
. Then press or again to make the
selection.
2. In the
SEARCH TIME
, user may now select the date
and time from where you want to begin the video
playback.
TIME SEARCH
START TIME
END TIME : 2006 / 05 / 05 13 : 08 : 13
: 2006 / 05 / 04 10 : 00 : 01
: 2006 / 05 / 04 10 : 00 : 01SEARCH TIME
HARD DISK :

Use the and buttons to move the selection to the left and right. Use the and
buttons to select the date and time. Then press or again to make the selection.