User manual

Name Function

corresponding subnet mask to be filtered.

Range

– assign a range of IP address to be filtered.

3. Save to add the created data in the filter list or Cancel to

void the operation and exit.

System > Network

In this section, only admin level is authorized to set up the Network settings.

assign

eting the setting, click Save to apply the new setting and

Canc

System > Network > Setting

In Setting tab, you can configure the type of network connection for IP camera and

name for the IP camera. Depending on the network connection, IP camera can be

accessed from the computer within the same local area network (LAN) or anywhere with

Internet connection. After compl

el to keep the old setting.

(2)

(1)

(3)

Name Function

(2) witch

(1) Device Name Assign name for the IP camera.

Network HW S

tting.

sure the dip switch behind the IP

amera is set properly.

Enable/disable to use the IP camera dip switch network se

If this is enabled, make