User manual

settings and then click [Apply]. This will change the setting and rescan the network
again.
10
6.
6. The IE browser will open and direct you to IP camera login page. This requires
IPViewer.ocx to run. If the IE ActiveX warning message appears, click to allow running
the add-on.
Using NON-DHCP Server/Router Network
In Non-DHCP server/router network, the static IP address must be assigned to the device
and each time when adding another IP camera in the network, the default IP address of the
current one must be changed to avoid conflict .
Default IP : http://192.168.1.168
1. Make sure the DIP switch behind the IP camera is set to Static IP.
2. Connect the computer to the network and set the IP
address with the same subnet prefix of 192.168.1.XXX.
The last decimal number should be set any from 1 to
255 except 168 and other IP addresses that are
already being assigned. Then set the Subnet Mask to
255.255.255.0.
To change the computer IP address, go to Control
Default ID : admin
Password : admin