User manual

Factory Default

1. Remove the Ethernet cable and power adapter.

2. Take an electronic wire, plug one side of the wire into “Default” and the other side into “GND” on

the terminal block as the photo below.

3. Connect power again and connect Ethernet cable after the camera finishes rebooting..

4. Remove the wire. When camera starts again, please remove the pink default cable and plug

Ethernet cable for new setting.

5. Release the button when camera finishes proceed.

6. Re-login the camera using the default IP (http://192.168.1.200) or DHCP, and user name (admin),

password (admin).