User`s manual

26
D. Event List
IP Camera provides multiple event settings.
 Event Setting
 Motion Detection: IP CAMERA allows 3 areas motion detection. When motion is triggered, it can
send the video to some specific mail addresses, transmit the video to remote ftp server, trigger the
relay, and save video to local SD card. To set up the motion area, click “Area Setting”. Using mouse
to drag and draw the area. The same operation for area 2 and 3.
 Record File Setting: IP CAMERA allows 3 different types of recording file to change its record size.
When motion/alarm is triggered, there are 3 different types of record mode.
 AVI File (With Record File Setting )
 Multi-JPEG (With Record File Setting), only with JPEG compression format.
 Single JPEG (Single File with Interval Setting)
 Record Time Setting: Pre Alarm and Post Alarm setups for video start and end time when motion
detected, I/O, or other devices got triggered.
[Note] Pre/Post Alarm record time is base on record time setting and IP Cam built-in Ram memory.
Limited by IP Cam built-in Ram Memory, When information is too much or video quality set too high, it
will cause recording frame drop or decrease on post alarm recording time.
 Network Dis-connected: When the network is down, it will save the video to local SD card.
[Note]This function is only enabled in wire connection.
 Network IP check: When the connection is down, it records the video to SD card. Make sure the
video recording is continuous. To use this function, key in the IP address of the PC which has
recording software installed. Enable the function of “Save to SD card”, then click “Apply”.
[Note] The interval of two video files on SD card is fixed with 30 seconds.