Installation guide

Remote Control
The remote control requires two (2) “AAA” size batteries (supplied), make sure batteries are
installed properly before using. Aim the remote control to the HVC camera infrared sensor
to operate the unit.
Name
Function
(4)
(8)
(3)
(5)
(23)
(22)
(12)
(10)
(17)
(16)
(2)
(1)
(18)
(19)
(20)
(14)
(6)
(7)
(9)
(15)
(13)
(11)
(21)
(1) Call
Start a call or add another party.
(2) Phone Book
 Search contact to make a call.
 Enter to add, edit, delete or create group
contact entry.
(3) Enter
 Make a selection in OSD menus or on-
screen keyboard.
 Accept incoming call.
 Display the site name and icon during the
meeting.
(4) ▲,▼,◄, & ►
 Use these buttons to navigate through the
selections in OSD menus or on-screen
keyboard.
 Pan the zoomed in camera image or the
captured image.
 Move around within the zoomed in camera
image or the captured image.
(5) Present
Share either the video/image from the VGA IN
port or the captured image.
This present icon will appear on the
screen to indicate sharing the present image.
The present icon will disappear in 5 sec.
(6) Vol +/-
Increase/decrease the speaker volume.
(7) Zoom +/-
Zoom in/out the camera image or the captured
image.
(8) Mute
Turn on/off the MIC. This mute icon will
appear when the mic is turned off. The mute
icon will become translucent in 5 sec.
(9) Preset
 Press hold for 3 sec to set the position of the
camera preset point from the selected number.
The preset point can be set from 0-9.
 Press to move the camera target to the
selected preset point number.