Specifications

www.avenview.com|9
1.9 Installation (SW-HDM3D-C6-8x8E)
To setup Avenview SW-HDM3D-C6-8x8E follow these steps for connecting to a device:
Matrix Switch
1. Connect all sources to HDMI Inputs on the Matrix Switch (SW-HDM3D-C6-8x8E)
2. Connect each HDMI CAT 5/6 output on the SW-HDM3D-C6-8x8E to respective CAT 5/6 input on the
remote receiver HDM3D-C6SW-R
3. Connect IR BLASTER cable to the SW-HDM3D-C6-8x8E and direct the IR emitter to the build-in IR receiver
of the sources
4. Connect the +5V 6A DC power supply to the SW-HDM3D-C6-8x8E
5. Power on all HDMI sources
6. Power on the SW-HDM3D-C6-8x8E
Receiver
1. Connect each HDMI output to HDMI displays.
2. Connect the CAT5E/6 INPUT on the HDM3D-C5SW-R to the CAT5E/6 OUTPUT port on the
SW-HDM3D-C6-8x8E.
3. Connect IR receiver and place the IR receiver at the appropriate position that can receive the IR command
signals sent from the users.
4. Dial the 8-level rotary control switch to adjust the HDMI signal level until the picture and sound are clear.
It is recommended to dial from 7 to 0 to find the optimal visual experience.