User manual

RMT-4IR INSTALLATION
1. Remove battery cover from the back of the RMT-4IR remote.
2. Verify that dip switches 1 & 2 are in the down (OFF) position. (See page 6)
3. Insert the battery, hold the battery so that you can see the positive side facing up.
The side that is not marked must be facing down.
4. Test the RMT-4IR remote by pressing ONLY one button at a time. The indicator
light on the remote will ash once each time you press a button.
WARNING:
Do not press multiple buttons simultaneously and do NOT press buttons rapidly.
These actions will cause the remote to reset and steps 1-4 will have to be repeated.
Note: The RMT-4IR ships with two batteries. Only one battery is required for
operation, the other battery is complimentary.
5
The optional IR extender allows you to
relocate your HDMI Switcher and still retain IR
control. Linear part# IR-EXTENDER