User guide

8 HDMI 4x1 Selection Switcher User Guide
Auto-switching mode and manual-switching mode can be set by pressing the input 1
button, or by entering an RS232 command. Auto-switching mode is the factory default.
The operations are listed below.
Button control
Pressing INPUT 1 for three seconds toggles the switch between auto-switching mode
and manual-switching mode. The Auto-SW LED designates which mode it is currently
in.
RS232 control
Sending the RS232 command “602%” sets the switch to Manual mode and turns off
the Auto-SW LED. Sending the RS232 command “601%” sets the switch to Auto mode
and the Auto-SW LED turns on.
Panel drawing
Figure 4: Top view
Figure 5: Front view