Specifications

www.avenview.com

Page 7

4. PANEL DESCRIPTION

4.1 INPUT PANEL (Transmitter, HBT-C6POE-S) Front

1. HDMI IN: Connect

HDMI source Max 35ft

via HDMI Cable Blu-ray

player or Digital player

2. LAN Connect to a router for LAN sharing. This allows network/internet

access) to be shared over the CATx to the RX.

Warning: DO NOT connect the LAN connection to the CAT5e/6/7 output,

this may trigger a power shut down and may damage the device.

3. RS-232 IN: Connect to a device that has the ability to send control commands ( PC or laptop via D-Sub

9-pin male cable)

4.2 INPUT PANEL (Transmitter HBT-C6POE-S) Rear

4. DC 24V: Connect the 24 V DC power supply in-

cluded. Secure screw connector.

5. POWER LED: This blue LED will illuminate when the

device is connected to a power supply.

6. IR 1 Blaster: Plug the IR Blaster cable for IR signal

being transmitted. Place IR Blaster within direct site

of the device being controlled.

7. IR 2 Extender: Plug the IR Extender cable for IR signal

being received. Place IR Extender within direct line of

site with the IR Remote.

8. LINK LED: Illuminate when both the input and

output signals are in sync. The LED will blink inter-

mittently to indicate no signal is being received from

the display and irregularly to indicate that an error

has occurred.

9. CAT5e/6/7 OUT: Connect CAT5e/6/7 cable to trans-

mit all data signals extend the signal to the Rx unit.

5 4 6 7 8 9