Specifications

www.avenview.com

1.8 Installation

To setup Avenview DVI-SPLITPRO-4X follow these steps for connecting to a device:

1. Mount or fix the DVI-SPLITPRO-4X safely

2. Switch off DVI-SPLITPRO-4X and all source devices and displays that will be connected

3. Connect a monitor, projector, other displays that come with DVI / VGA inputs by using 1 male – male

DVI cable to DVI-SPLITPRO-4X DVI output. (you can connect 2 displays equipped with DVI and VGA

respectively by DVI – DVI/VGA Y cable

4. Plug-in DVI to DVI/VGA breakout cable to DVI-Component-VGA and plug in VGA to Component

adapter to VGA connector of the breakout cable

5. Connect a device equipped with DVI output (such as PC) to the DVI connector of the breakout cable

6. Connect a device equipped with the component video output to 3-RCA jack of the Component video

adapter

7. Connect a device with VGA output (such as laptop) to VGA connector of DVI-SPLITPRO-4X

8. Connected a device with Composite or S-Video video output to composite input of DVI-SPLITPRO-4X

through S-Video / Composite Y cable.

9. Connect your computer to DVI-SPLITPRO-4X via RS232 cable and then install the software

10. Turn ON DVI-SPLITPRO-4X

11. Run the Control Software and establish the connection between PC and DVI-SPLITPRO-4X

12. Turn ON all connected devices and then control the display output thru RS232 and included software