User manual

ManualsBrandsAvenview ManualsTV Converter BoxC-HDMI-DVIA

www.avenview.com

FO-DVI-XX-MM Series

User’s Guide

Models

FO-DVI-XX-MM

The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations

or warranties with respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to

specifications and product descriptions at any time without notice. No license, whether express, implied, or otherwise, to any intellectual

property rights is granted by this publication. Except as set forth in Avenview Standard Terms and Conditions of Sale, Avenview assumes

no liability whatsoever, and disclaims any express or implied warranty, relating to its products including, but not limited to, the implied

warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.

Reproduction of this manual, or parts thereof, in any form, without the express written permission of Avenview Inc. is strictly

prohibited.

Summary of content (17 pages)

PAGE 1
FO-DVI-XX-MM Series User’s Guide Models FO-DVI-XX-MM © 2008 Avenview Inc. All rights reserved. The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations or warranties with respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any time without notice.
PAGE 2
Table of Contents Section 1: Getting Started ...................................................................................................................... 4 1.1 Important Safeguards ............................................................................................................ 4 1.2 Safety Instructions ................................................................................................................. 5 1.3 Regulatory Notices Federal Communications Commission (FCC) ..
PAGE 3
www.avenview.
PAGE 4
Section 1: Getting Started 1.1 Important Safeguards Please read all of these instructions carefully before you use the device. Save this manual for future reference. What the warranty does not cover   Any product, on which the serial number has been defaced, modified or removed. Damage, deterioration or malfunction resulting from:  Accident, misuse, neglect, fire, water, lightning, or other acts of nature, unauthorized product modification, or failure to follow instructions supplied with the product.
PAGE 5
1.2 Safety Instructions     Do not dismantle the housing or modify the module. Dismantling the housing or modifying the module may result in electrical shock or burn. Refer all servicing to qualified service personnel. Do not attempt to service this product yourself as opening or removing housing may expose you to dangerous voltage or other hazards   Keep the module away from liquids. Spillage into the housing may result in fire, electrical shock, or equipment damage.
PAGE 6
1.5 Model Description FO-DVI-XX-MM Model Name 1.6 Length in Meters (5 = 5 meters, 10 = 10 meters) Package Contents Before you start the installation of the converter, please check the package contents. - DVI Optical Cable with Receiver and Transmitter - User’s Manual 1.7     Before Installation Put the product in an even and stable location. If the product falls down or drops, it may cause an injury or malfunction.
PAGE 7
1.8 Installation This product is composed of a Transmitter converting the graphic signal of a computer to optical and Optical Fiber propagating the optical signal and Receiver supplying electrical signal to monitor converted from the optical signal to electrical signal. The Transmitter should be connected to computer and the Receiver should be connected to a monitor (as shown below).
PAGE 8
1.9 General Troubleshooting Problem No Image Screen Defects Appear Possible Solution       Check if the PC Power is on Check if connection to the computer and the monitor are correct. Turn the PC Power off and on again. This product supports up to UXGA resolution. Check the DVI connection Check the maximum resolution range of the graphics card. www.avenview.
PAGE 9
Section 2: Specifications Item Video Bandwidth Connector Power Consumption Supported Resolution and Distance Description 1.65Gbps (Single Link) DVI 24Ping Plug 5V / 0.5A (min) SXGA 1280 x 1024 @ 700 meters (2300 feet) UXGA 1600 x 1200 @ 500 meters (1650 feet) WUXGA 1920 x 1200 @ 100 meters (330 feet) Optical Optical Source 850nm VCSEL O/E Converter Fiber Type PIN Photo Diode Multi-Mode Fiber Environmental Operation Storage 0˚ to 50˚C Degree -20˚ to 70˚C Degree 2.1 Part List www.avenview.
PAGE 10
Item Q’ty Description Material A DVI-D Single Link 18 Plug 2 Glass filled thermoplastic UL94V-0 B DVI Case-Top, Bottom 2 Glass filled PC UL94V-0 C DVI Thumb Screw 4 SUM 24L+ABS D Stopper 2 PVC 55% E Epoxy Printed Circuit Board for Tx 1 FR-4, 1.5t UL94V-0 F Optical Connector for VCSEL,PD 2 PA46 UL94V-0 + C5210 G Optical Connector for fiber 2 PA46 UL94V-0 H Epoxy Printed Circuit Board for Rx 1 FR-4, 1.
PAGE 11
2.3 Signal Pin Assignment - Fully compatible with DVI Rev 1.0 standard R, G, B and Clock signals are transmitted by optical fibers. DDC, Hot plug detection signal and 5V power is transmitted by electrical copper wire. External power is not required for operation Pin Signal Assignment Pin Signal Assignment Pin Signal Assignment 1 T.M.D.S. Data2- 9 T.M.D.S. Data1- 17 T.M.D.S. Data0- 2 T.M.D.S. Data2+ 10 T.M.D.S. Data1+ 18 T.M.D.S. Data0+ 3 T.M.D.S. Data2 Shield 11 T.M.D.S.
PAGE 12
2.5 Characteristics of FO-DVI-XX Cable 2.5.
PAGE 13
2.6 FO-DVI-XX Cable Construction The construction of 4 Optical Fibers and 4 Copper wires cable shall be in accordance with Figure and Table below: The Dimension of FO-DVI-XX-MM Cable Items Uni t- Layer Stranding mm(AWG) -0.203/7 (24) AL-Mylar Screen Shield - A helically Cable Outer Diameter mm 7.40±0.20 DVI Cable Make-up Drain Wires (Size/Stranded) Jacket Color - Cable Marking - www.avenview.
PAGE 14
2.7 Physical Interconnect Specification 2.7.
PAGE 15
2.7.2 Connector Electrical Characteristics Item Test Condition Requirements Contact Resistance ANSI/EIA-364-23 Shell Resistance ANSI/EIA-364-06A-83 Contact resistance measured from receptacle shell leg to plug cable braid.
PAGE 16
Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc.
PAGE 17
regarding such products, including but not limited to, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement. www.avenview.