Installation guide

VENDOM

6: Pan/Tilt/Zoom Camera Connection Guide

RS232/485 Converter

This converter is for the control of Pan/Tilt which are supported in the

RS232/485 Port

1. Connect DB9 pin cable between the serial Port in the motherboard board and RS232 port in

this converter.

RS-422/485 Connector

Pin name Pin number

Ground 1

- TxData 2

+ TxData 3

- RxData 4

+ RxData 5

Ground 6

This is what the RS 232-485 Connections look like,

you need to connect the Controller Cable from the

P/T/Z to this connection as shown above (RX+ and

RX-).When you do this, make sure that your P/T/Z’s

Dip switches are set to the specified camera Channel

and com port that you chose, otherwise it will not

work*