Setup guide

Mobile DVR DMB-X Installation and Setup Manual v2.5 © Aventura Technologies 2009 Page 6 of 30
3.1.2 Pin 3 is a switched voltage used to turn the Mobile DVR on/off. An input on this pin
above 11.6Vdc will turn the DVR on and maintain it in the on-state.
3.1.3 Note: - The DVR is factory preset to continue recording for 30 minutes after the
voltage on the IGN lead is removed.
4.0 Setting Up
All the required software and default settings are pre-installed.
Power up the DVR and wait till the system is fully operational, you will either see a
connected camera display or the “No Video Signal” message displayed.
Depending on your setup method (touch screen or mouse), either double tap the centre of
the touch-screen or double click with the mouse. Once you have double tapped
(“activated”) you will be presented with the following screen:
Once you are in this screen you can see there are sub menus. We will go through each
menu one at a time but first we need to logon.
4.1 Log On
Click on the “Camera 1 Setup” bar and the following screen will be displayed:
Enter a valid username and password (the default username and password being admin
and admin) into the respective boxes and press “Log on”.