Setup guide

Mobile DVR DMB-X Installation and Setup Manual v2.5 © Aventura Technologies 2009 Page 5 of 30
3.0 Powering the Mobile DVR DMB-X Series
VERY IMPORTANT:
The correct wiring of the power connections is Vital to ensuring fully operational
functionality of the Mobile DVR series of DVRs.
Any deviation from these wiring instructions can be expected to result in a wide variety of
functional deficiencies.
3.1 Power Connections
The connections on the power plug are numbered 1 to 3 as below:
Power Input
Pin 1 – +SW - Switched input (12 - 24V DC)
Pin 2 – GND - (with respect to +Ve)
Pin 3 - +Ve (12 -24V DC)
NB: - Supplied lead is wired as follows. Blue = +V Green/Yellow=GND Brown=+SW.
An inline fuse of 7.5amp is required on the +Ve wire.
Power Output to HDD
Pin 1 is +5v Output
Pin 2 is Gnd
Pin 3 is +12 V output
3.1.1(+Ve) Pin 1connection must be wired directly to the vehicle’s +Ve battery Terminal (or
to a strap connected directly to the battery terminal), through a 7.5Amp inline automotive
fuse.
2
1
3
1
23
2
1
3
1
2 3
1
2 3