Use and Care Manual

Test Report
No.: SHHL1909051579IF Date: NOV. 25, 2019 Page: 5 of 19
Clause
Test Method / Requirement
Result
Rating
Protect the sample on its edges and its rear face, to avoid
contact with water.
On completion of this test, no blister (i.e. density 0), porosity,
cracking or fibre prominence, shall be detected on the surface
after testing, compared to a control specimen as defined in
EN ISO 4628-2.
Only the manufacturer is concerned with this test method
which shall be applied for each new manufacturing process.
This test is only applicable before installation of the product
for the end user.
A longer test period may validate a higher integrity of the
polymer.
For polyester shells, refer to Annex D for additional
requirements.
4.4.4 Wood Structural elements made of wood or wood-based material
shall meet the requirements of use class 4 according to EN
335.
Compatible woods may be chosen according to two distinct
approaches:
- using naturally durable woods (excluding sapwood) as
defined in EN 350-2, that meet the requirements for use in
applicable hazard classes in EN 460.
- using wood with conferred durability (preservation
treatments while conserving the sapwood), that meets the
requirements for use in applicable hazard classes in EN 351-
1.
To achieve the parameters stated in prEN 16713-3, the water
treatment has to be adjusted in the case of wooden material
in contact with the water.
No wood N/A
4.5 Injury risks
4.5.1 Small
elements,
edges and
corners
When the swimming pool is being used, any protrusion on
accessible parts liable to present a risk of injury shall be
protected by a method which in order to be removed, requires
the use of a tool or a minimum amount of force of 60 N, with
an accuracy of 2 N.
During the installation, equipment made of wood, fibreglass,
or other materials shall be free of splinters.
Small accessible and grippable elements shall not fully enter
into the template shown in Figure 3 (EN 71-1) or they shall be
fixed to the item to which they belong such that they cannot
be detached under a force of 60 N, with an accuracy of 2 N,
applied in any direction whatsoever.
All edges, protruding parts and corners accessible without
use of tools or minimum amount of force of 60 N (± 2 N) shall
be designed not to cause any injury. When necessary they
shall be treated appropriately to remove this risk (see Figure
4).
/ Pass