Use and Care Manual

Test Report
No.: SHHL1909051579IF Date: NOV. 25, 2019 Page: 16 of 19
Clause
Test Method / Requirement
Result
Rating
4.1 General For new basin designs and for existing basin constructions
that are structurally modified, the following tests shall be
carried out with at least one test sample.
See Below Pass
4.2 Aboveground swimming pool with frame
-
supporting walls
4.2.1
Resistance to
horizontal
deformation
On completion of the test defined in 4.2.1.2, the swimming
pool shall not collapse and shall meet the requirements set
forth in EN 16582-1:2015, 4.5.
/ Pass
4.2.2
Resistance to
vertical
deformation
On completion of the test defined in 4.2.2.2, the entire
product shall not suffer any permanent deformation affecting
its structural integrity.
/ Pass
4.2.3 Bursting
strength
The bursting strength test defined in 4.2.3.3 is performed
after carrying out the resistance tests for horizontal
deformation (4.2.1.2) and vertical deformation (4.2.2.2).
On completion of the test defined in 4.2.3.3, the pool shall not
burst and shall not suffer any permanent deformation
affecting the product's structural integrity.
/ Pass
4.3 Aboveground swimming pool with self-stabilizing walls
4.3.1 Capacity
to stop an
overflow
On completion of the tests described in 4.3.1.2 and 4.3.1.3,
the swimming pool with self-stabilizing walls shall not
collapse or empty suddenly.
/ N/A
4.3.2 Inflatable
compartment
The swimming pool with self-stabilizing walls generally
comprises an air-inflatable upper tube. In this case, all of the
air inlets provided for inflation shall be fitted with caps
permanently secured on an accessible part of each inflatable
compartment of the swimming pool with self-stabilizing walls.
Once this part is inflated, the caps located inside the
swimming pool with self-stabilizing walls shall be able to be
pushed back inside the upper part so that they do not
protrude from the surface by more than 5 mm.
The caps of the inflation ports should not be able to become
detached and should be protected against accidental
removal. Check valves shall be fitted in order to prevent an
instantaneous deflation.
/ N/A
4.3.3 Stability in
the event of
deflation of the
upper tube
On completion of the test described in 4.3.3.2, the swimming
pool with self-stabilizing walls shall not collapse.
/ N/A
4.3.4 Bursting
strength
On completion of the test defined in 4.3.4.2, the swimming
pool with self-stabilizing walls shall not burst and shall not
present any permanent deformation affecting the product's
resistance.
/ N/A
4.4 Mechanical
strength of the
membrane of a
The membranes composing the structure of swimming pools
(see Figure 1 and Figure 2) shall meet the following
requirements:
See Result 1
See Remark 2
Pass