Specifications

The user must be careful to unplug the LAN cable from the ATM or POS. The ATM or
POS has the protection when there is no comunication between the ATM and Host Server in
limited time your ATM will be offline automatically. This peroid is called the “ATM Time Out’.
This time out depends on your ATM system. It is approximately 6-10 seconds.
Stand alone Setup
Connect the PC/DVR cable (021-037-SF) which comes from the TCPIP232 adapter
to your laptop. Power up your TCPIP232 and your laptop and run serial program like Hyper
Terminal at baudrate 19200,n,81 with VT100 emulation. Press ESC key (1BH) , [ (5Bh) and
P (50H) to enter to the Main Menu.
Press Arrow key to move the cursor or change the configurations Press Enter key to select or
save the configurations.
IP ADDRESS
The IP address will be the same as the ATM or POS machine.
INFORMATION
This is a user define for additional information in the transaction to display special
information.
INTERFACE
Select Generic for stand alone mode if you connect with VSSI-Pro then select VSSI
for TCPIP232 will send raw data to VSSI-Pro to analyze the data but the VSSI-Pro is able to
use Generic mode by select TCPIP GENERIC when you program the VSSI-Pro.
Select REGCOM57600 or REGCOM9600 or VNET when you connect with RS485
network. Put jumper on JP9(1-2) , JP10(1-2) and JP11(1-2) for using AVE RS485 Network.
ID
Use when you select REGCOM57600 or REGCOM9600 or VNET.
SENSE
Select type of LAN cable for Straight Through or Cross Over cable if you select AUTO
then TCPIP232 will select cable type automatically.
Select EXIT and Unplug your PC/DVR Cable from your laptop and plug it to your DVR Com
port. Now your need to program your DVR to display text insertion.
TCPIP232 Setups
PAGE 4
TCPIP232 SETUP
* IP ADDRESS 192.168.0.1
- INFORMATION 0 ON
- INFORMATION 1 ON
- INFORMATION 2 ON
- INFORMATION 3 ON
- INTERFACE GENERIC
- ID 1
- SENSE AUTO
- EXIT