User manual

Installation and User Manual ADPRO FastTrace-R by Xtralis
78 Doc 13972_03
Note: A Transaction Device Software License must be purchased to enable transaction
device functionality. Licensing instructions are provided with the purchase of a
licence (refer to Licensing).
A Transaction Device (for example an ATM or EPOS terminal) can be connected to the
FastTrace-R via one of the GP Serial ports or Ethernet port. Up to sixteen transaction devices
can be configured.
Note: Please contact your nearest Xtralis office for details of supported equipment.
For information on how to set up a transaction device, please refer to the Transaction Device
Software Programmers Manual (document number 11620_01) available on the website -
www.xtralis.com/adpro.
4.3.11 Transparent Data Port
FastTrace-R supports transparent RS232 data transmission to/from VideoCentral. The port
labelled DATA on the rear of the unit is the port used for this connection. This functionality
provides the capability to transfer an RS232 data stream from the FastTrace-R unit to
VideoCentral, and vice-versa. This type of capability may be useful to support a camera station
that is not listed in the supported list for FastTrace-R, or controlling some other industrial
equipment at the remote site.
If a VideoCentral user connects to a FastTrace-R with transparent data enabled, the serial port is
reserved exclusively for use by that user. Until that user disconnects, no other user can access
transparent data.
Figure 76: Transparent Data Port Menu
To enable the Transparent Data Port check the Transparent Data Port Connected option.
Note: VideoCentral also requires configuration changes for this functionality (Database /
Administration / Configure Transparent Data Port).