User manual

Installation and User Manual ADPRO FastTrace-R by Xtralis
74 Doc 13972_03
If the Non-Interruptible option is selected, the following dialog box is displayed to warn the user of
the potential to cause events to be queued and add delays in capturing event images.
Figure 72: Alarm Preset Warning
Preset Positioning Time
Options: 0, 0.1, 0.2, 0.3, 0.4, 0.5, 1, 2, 3, 5, 10 seconds
Default: 1 second
The Preset Positioning Time is the delay (in seconds) between an alarm input trigger and the first
alarm image being captured to send to VideoCentral. This delay will allow a PTZ camera enough
time to move to its alarm preset and come to a stop before acquiring the first alarm image,
eliminating blurred or unuseable images being recorded.
Auto Home
Options: Always, Never
Default: Never
FastTrace-R can be configured to automatically send a PTZ camera station to pre-position 1
after a period of no PTZ commands being issued to that camera station, or configured to leave
the PTZ camera station in its current position. When the Always option is selected, a time value
is also necessary as explained below.
Auto Home Expiry Time
Options: 10 - 600 seconds
Default: 60 seconds
The Auto Home Expiry Time is the time (in seconds) that the FastTrace-R will wait, after the last
PTZ command, before sending the PTZ camera station to pre-position 1.
Note: Any queued preset request occurring during the period the FastTrace-R is in setup
mode will be cancelled. An alert will still be sent to VideoCentral, but image
information will not be available.
Note: During the Preset on Alarm function, images could appear dark and/or blurry,
possibly causing FastTrace-R to interpret this as low contrast, and generating a low
contrast alarm.