User manual

Installation and User Manual ADPRO FastTrace-R by Xtralis
72 Doc 13972_03
General Tab
Figure 70: Camera Settings - General Tab
Camera Name
Option: 16 characters maximum.
Type the name to be associated with this camera. Hint: Try to use names that make the camera
location and the channel number to which it is connected, easily identifiable. For example,
CAM07 LIFT LOBBY, REAR DOOR CH15 or CH09 ATM#3 EAST.
Colour/Monochrome Camera
Options: Colour, Monochrome
Default: Colour
This option is useful if monochrome cameras are being used on the system. When a particular
camera is defined as monochrome only (black and white), the processing hardware is able to
‘sharpen’ the images by bypassing some of the colour filter processing normally performed on
the signal.
Camera Terminated
Options: Ye s, No
Default: Yes (ticked)
Use the checkbox to define whether the selected channel (camera output) is terminated with a
75 ohm resistance. By default all channels are terminated.
Clear the checkbox when the video cable from the camera is to be connected to the FastTrace-
R’s video input via a ‘T-Connector’. In this case, the video may be fed to another piece of
equipment, for example a video switcher or a CCTV monitor.
Caution: Camera termination is only active whilst the FastTrace-R is powered. If, for any
reason, the power is removed from a FastTrace-R unit, any connected cameras will
become unterminated.
Use Activity Detection
The FastTrace-R can be setup to respond to changes that occur within the field of view of a
camera. This feature is used to trigger an alarm if activity is detected by a certain camera in an
area not normally expected to have activity.