User manual

ADPRO FastTrace-R by Xtralis Installation and User Manual
Doc 13972_03 61
Figure 64: Ethernet Settings
IP Address for this Unit
Factory Default 192.168.1.1
The IP Address is used to identify the FastTrace-R device as a TCP/IP network node. Each
ADPRO Transmitter monitored from the same installation of VideoCentral requires a unique IP
(Internet Protocol) address. The address is divided into four parts separated by a (.), each part
with a decimal range value from 0 to 255.
The following address ranges are invalid:
• 0.xxx.xxx.xxx
• 127.xxx.xxx
• 224-239.xxx.xxx.xxx
• 240-255.xxx.xxx.xxx
• xxx.xxx.xxx.0
• xxx.xxx.xxx.255
• 192.168.10.xxx
Caution: Changing the IP address may mean you can no longer connect to the FastTrace-R.
Caution: FastTrace-R can use two different types of interfaces, Ethernet and serial RS232, to
communicate with VideoCentral via an intermediate network. Each of the
communications interfaces on FastTrace-R has an IP address associated with it
(FastTrace-R has three IP addresses, one for each of the two serial RS232
interfaces and one for the Ethernet interface).
Each FastTrace-R must have unique IP addresses for each communications
interface. This will require management by the Monitoring Stations to ensure all
FastTrace-R units that communicate with the Monitoring Station have unique IP
addresses.
For more information, please refer to Tech-Tip - Unique IP Address Requirements,
available on the website: www.xtralis.com/adpro.