User manual

ADPRO FastTrace-R by Xtralis Installation and User Manual
Doc 13972_03 53
Figure 56: FastTrace-R User Settings
Note: Some options for a category can be affected by the status of other setting(s) and
may be unavailable (shown ‘ghosted’).
The programming GUI is a separate program to VideoCentral and there are numerous different
versions (although outwardly all look the same). The precise version used is dependent upon the
software installed on the FastTrace-R system being programmed. The programming software is
held on the remote FastTrace-R system and downloaded to the VideoCentral PC for use. For this
reason the programming screen may sometimes takes a few minutes to appear on the screen
(depending upon the speed of the connection to the FastTrace-R system). VideoCentral only
needs to download any given version of the programming software once, after this the software
is stored on the PC for use at a later time, speeding up the programming operation. Once the
settings (and set-up program if necessary) have been downloaded the programming software
will start automatically.
Selecting the Save to FastTrace-R button at any time will cause all settings currently within the
software to be sent to the FastTrace-R system (a confirmation box will be presented to verify the
required action). Before sending the new programming to the FastTrace-R, the software will
perform a check to make sure all settings are valid and any anomalies will be advised.
Once all settings are valid, they will be downloaded to the FastTrace-R system and the system
will be disconnected to allow the settings to take effect.
Selecting the Discard all changes button any time will close the Setup without sending any
settings to the remote FastTrace-R system (a confirmation box will be presented to verify the
required action).