User manual

Installation and User Manual ADPRO FastTrace-R by Xtralis

46 Doc 13972_03

Figure 50: RS485 PTZ Port Connections to a Telemetry Station

• Make sure the last telemetry station connected to the link is terminated by a 120 ohm

resistor.

• With reference to the telemetry station manual:

- connect the pan/tilt head and the zoom lens, focus control and iris control (if

applicable),

- set the lens voltage, high speed PTZ settings, A/D converter for preset systems,

homing preset after the last operation plus any other settings in the telemetry station,

and

- make sure the telemetry station data speed is set to the ADPRO recommended or

default baud rate.

Telemetry station manufacturers provide a variety of models and features. FastTrace-R provides

PTZ control ability for a number of popular models and where possible, supports the features

provided by the manufacturer. Due to the number of models available on the commercial market,

details of connection and use for individual models have been provided on the website.

For information regarding connection and features of specific telemetry station, please

refer to the technical documents section on the website at:

http://www.xtralis.com/adpro

or contact your nearest sales office for a copy.

3.10 General Purpose Serial Ports

Two general purpose serial ports are provided on the unit to support RS232 communication to

third party equipment, for example transaction devices such as ATM / EPOS machines. The

connectivity is shown below.

If using the GP Serial Port for ATM /EPOS, please ensure that configuration switch 9 is in

the correct position prior to boot-up.

Figure 51: Pin Numbering of the Serial Port

2 (+)

3 (-)

Balanced

Transmit/

Receive

Ground

PTZ Camera Station

RS422/485 Port

FastTrace

PTZ Port

(+)

(-)

Ground

Balanced

Transmit/

Receive

RS485 ft connection.cdr

Shield