User manual

ADPRO FastTrace-R by Xtralis Installation and User Manual
Doc 13972_03 31
Note: ALWAYS consult with the IT or Network Manager for the network BEFORE
physically connecting FastTrace-R to the network.
A network address is required for correct operation over a network. Both the FastTrace-R and
the PC running the VideoCentral software must have a unique TCP/IP address (referred to as
the IP address). A number of IP parameters may need to be entered to correctly identify a
FastTrace-R on a network.
Refer to Section 4 - Ethernet Properties for details to configure the Ethernet Connection.
3.3 Audio
Audio functionality is provided via two connectors on the FastTrace-R. Audio options are only
available if the system has a sound card enabled. Audio to/from a remote site using VideoCentral
is half-duplex, meaning that audio is only allowable in one direction at a time.
3.3.1 Audio Switch Port
The Audio Switch port provides a number of functions on the FastTrace-R, these are:
• An audio output and an audio input connection
• A general relay
• Serial outputs
• Access Secure input
Figure 34: Audio D-Connector Pinouts
Pin 1
Pin 15
Pin 8
'AUDIO SWITCHER'
15-pin D Male Connector
P73 audio pinouts d-conn.cdr