User manual

ADPRO FastTrace-R by Xtralis Installation and User Manual
Doc 13972_03 23
Figure 28: FastTrace-R User Settings
Setup parameters and configuration options for the FastTrace-R can now be modified.
Refer to Section 4 - Programming FastTrace-R for details of the settings which must be defined
to use the FastTrace-R in an operational environment.
8. Define all required FastTrace-R user settings and select the Save to FT-R button.
The modified files will be uploaded to the FastTrace-R for permanent storage and the site
will be disconnected.
Note: The setup program will not allow invalid parameters to be saved. For example,
should you receive a message asking for a correct Ethernet Gateway address to be
entered, either enter the correct value or delete the invalid entry.
2.10 Adding a New Site
To connect to the site again, VideoCentral must be configured with a new site, which has the
Ethernet or Serial Communications properties identical to those entered at the Site Details and
Communications screens of the user settings:
1. Select Database / Administration / Configure Sites and select New.
The Site Configuration screen is displayed: