User manual

Installation and User Manual ADPRO FastTrace-R by Xtralis
98 Doc 13972_03
Activate Control Output
When checked, the control output correlating to the camera channel number currently being
programmed will be activated for a period as defined in the Alarm Input / Hold Time (refer to
Alarm Input Settings) upon full activation of an event. Refer to Control Outputs.
Note: If the assigned Control Output number has been specified for Manual Operation,
then an error message will be displayed.
Generate Alarm on Video Loss
Options: Ye s, No
Factory Default: Ye s
When checked, FastTrace-R will generate and alarm in the event of lost video on this camera
channel due to camera disconnection or output failure. Note that this operation is looking for
presence of video by the Sync Pulse - this is not a Contrast (or 'Black-bag') alarm.
Important: If the camera Recording Type has been set to ‘Do Not Record’, then a
‘Generate Alarm on Video Loss’ will not occur. There must be a
Recording Mode selected for an alarm to be generated.
Generate Alarm on Invalid Contrast
Options: Ye s, No
Factory Default: No
Select the Generate Alarm on invalid contrast checkbox if operators are to be notified if a
Contrast Alarm condition occurs on this camera. A contrast alarm will occur if the camera
contrast level changes to a level that lies outside of a user definable range.
Important: If the camera Recording Type has been set to ‘Do Not Record’, then a
‘Generate Alarm on Invalid Contrast’ will not occur. There must be a
Recording Mode selected for alarm generation to occur.
Record Audio on Event
When checked, audio will be automatically recorded when an event is triggered on this channel
during the current mode. If the VM22A Audio Switcher is being used, audio relating to this
camera channel will be recorded.
Note: As there is only one audio channel, Live Audio has priority over Alarm Audio
and Alarm Audio has priority over normal recording.