User manual

ADPRO FastTrace-R by Xtralis Installation and User Manual
Doc 13972_03 97
If using the Only When ALL Inputs Occur logic, only the first pre-set on the list will be active. If
another Alarm Input is configured for the same PTZ camera, its preset will not be available, and
will be displayed with an (N/A) beside the Preset Position.
Note: Please refer to PTZ Tech Tips for connection and setup information on the website -
www.xtralis.com/adpro.
Editing a Detector’s Preset
To edit a detector’s preset:
1. Double click the event input to be modified. The Event Input Settings dialog box is
displayed.
Figure 97: Event Input Settings
The Type and Source selections are greyed out, enabling the operator to only change the PTZ
Preset Settings.
2. Enter the appropriate settings and click OK.
Event Response
Once an Event has been declared, the Event Response settings are used to define the actions
that will be taken in response to the Event.
Figure 98: Event Response Tab