User manual

ADPRO FastTrace-R by Xtralis Installation and User Manual
Doc 13972_03 91
Note that this calendar uses days and not dates, therefore it is not possible to set specific
operations for particular dates such as Christmas or New Year.
Highlight a block within the calendar (this can spread across days as well as times) to be
changed by placing the mouse pointer within the calendar, holding down the left mouse button
and then dragging the pointer. Upon releasing the mouse button a dialog box is presented with a
drop-down selection box providing the options of the various modes (mode names must have
been pre-configured).
4.3.19 Audio Behaviour
The Audio Behaviour page determines whether audio information will be recorded to the hard
disk(s) during the different modes.
Figure 89: Audio Behaviour Settings
Select the Mode of operation for which the audio is to be configured and then use the check-box
to select whether audio is to be continuously recorded throughout this mode.
Enabling the Record Audio using Microphone checkbox will cause the FastTrace-R to record
information from either a microphone or line input connected via the Audio Connector on the
rear panel. Recording will occur whenever the unit is using the assigned Mode and will be
replayed when any camera is selected.
If the Audio Input device has been configured as Switcher in the Connected Equipment /
Audio screen, it is also possible to select which audio channel of the switcher will be recorded
(the names presented are the camera names). This allows different audio channels to be
recorded throughout the course of the day / week as required.
Note: FastTrace-R is not an audio multiplexer system - i.e. it cannot record multiple
channels of audio simultaneously. Only one channel of audio can be recorded at
any one time.