User manual

Installation
1 - 14 ADPRO FastTrace, Issue 5
The pinouts for the 9-pin D male connectors are shown.
Table 1-4 - GP Serial port pin outs
1.12 PTZ Port
Telemetry stations are used for the control of cameras with Pan/Tilt/Zoom (PTZ) hardware. They are connected to the
ADPRO FastTrace and can be controlled by commands issued via the PTZ port connector.
ADPRO FastTrace supports a number of PTZ telemetry station models provided all of the PTZ units are the same
model. Communications with the telemetry stations utilises RS485 ‘multi-drop’ signalling via the ‘PTZ’ port on the
rear of the chassis.
Figure 1-4 - Typical RS485 connection to multiple telemetry stations
FastTrace V1.02 and above supports ‘Down the Coax’ telemetry. A ‘Down the Coax’ module is required to be
installed in the FastTrace if this functionality is required. Please contact your ADPRO service centre if this option is
required.
PIN SIGNAL DESCRIPTION
1 DCD Carrier Detect
2 RXD Receive Data
3TXDTransmit Data
4DTRData Terminal Ready
5GNDGround
6DSRData Set Ready
7RTSRequest to send
8CTSClear to send
9RIRing Indicator