User manual

Installation and User Manual ADPRO FastTx by Xtralis
42 Doc 11949_06
3.8 Control Outputs
ADPRO FastTx transmitters have 10 or 20 Control Outputs that can be controlled by a remote
operator using ADPRO VideoCentral. The devices can be used to control operation of lights,
gates / doors and control equipment.
Note: Each Control Output can be set to be active (switch on) when an alarm event is
active on the corresponding channel or to respond to remote control via ADPRO
VideoCentral.
The devices should not be used to directly connect to third party equipment. They are primarily
designed to drive relay contacts, which in turn control the third party equipment.
3.8.1 Connecting to the Control Outputs
Control Outputs are available via screw connection strips on the rear panel.
Figure 45: Pinouts for Control Output Connectors
Caution: Exceeding the Control Output’s maximum voltage or current rating
(12 Vdc, 100 mA) will damage the ADPRO FastTx and invalidate the product
warranty.
For high power/voltage equipment, suitable interface circuitry must be used
between the Control Outputs and the equipment.
A typical output circuit for an external relay is shown below:
Figure 46: External Relay - Typical Output Circuit