User manual

Installation and User Manual ADPRO FastTx by Xtralis
38 Doc 11949_06
The video output cannot be controlled under normal day to day operation and will provide a
sequence of images as defined in Monitor Settings, refer to Monitor Settings on page 78. This
may be used in environments such as entrances to buildings etc, where CCTV is being used, to
act as a deterrent.
3.6 Configuration Switches
Some of the ADPRO FastTx settings and functions are set by the configuration switches on the
rear panel.
Settings shown in bold are the factory default positions.
Table 7: DIP Switch Configuration
Switch Function
1On
Off Factory Set
2 On Factory Set
Off
3On
Off Factory Set
4On
Off Factory Set
5 On RS422 Configuration for PTZ port
Off RS485 Configuration for PTZ port
6 On Impounded
Off Normal Operating Position
7 On Default override setting for direct connection
Note: Refer to ADPRO FastTx Connection Details Lost
on page 25 for an explanation of this switch
functionality.
Off Normal Operating Position
8 On PTZ RS485 Termination On
Off PTZ RS485 Termination Off
9 On GP Serial 2 is enabled for EPOS/ATM interfacing
Off Factory Set
10 On NTSC Video Standard
Off PAL Video Standard
11 N/A Leave both switches 11 and 12 in the ON position
12 N/A