User manual

Installation and User Manual ADPRO FastTx by Xtralis
26 Doc 11949_06
OR
- (SERIAL connection) Set 'Connection Type' = PSTN and 'Phone' = 0
6. Connect to Site (FASTRACE) using the default Password (FT2222).
7. Go to the Connection menu and select the Installer Menu option to display the ADPRO
FastTx's User Settings menu.
8. Change Site Details to the new Site ID, Password and Network Address values.
9. Save all changes when exiting the User Settings menu.
10. Reset Switch 7 to the OFF position and power cycle the unit.
The ADPRO FastTx will now operate with the new Site ID, Password and Network Address.
2.14 Firewall Configuration
If the ADPRO FastTx unit is connected via a firewall, the following table describes the destination
port allocation for the ADPRO VideoCentral PC and ADPRO FastTx unit. Source ports are
randomly chosen. The control of connections should be done using IP addresses and destination
ports.
Table 1: Firewall Ports
Destination Ports on ADPRO VideoCentral Destination Ports on ADPRO FastTx
UDP 15000-15200 UDP 15000-15005
TCP 15001-15007 TCP Any port