User manual

ADPRO FastTx by Xtralis Installation and User Manual
Doc 11949_06 23
The ADPRO FastTx User Settings screen is displayed.
Figure 28: ADPRO FastTx User Settings
Setup parameters and configuration options for the ADPRO FastTx can now be modified.
Refer to Programming ADPRO FastTx on page 51 for details of the settings which must be
defined to use the ADPRO FastTx in an operational environment.
8. Define all required ADPRO FastTx user settings and select the Save to FastTx button.
The modified files will be uploaded to the ADPRO FastTx for permanent storage and the
site will be disconnected.
Note: The setup program will not allow invalid parameters to be saved. For example,
should you receive a message asking for a correct Ethernet Gateway address to be
entered, either enter the correct value or delete the invalid entry.
2.10 Adding a New Site
To connect to the site again, ADPRO VideoCentral must be configured with a new site, which has
the Ethernet or Serial Communications properties identical to those entered at the Site Details
and Communications screens of the user settings:
1. Select Database / Administration / Configure Sites and select New.
The Site Configuration screen is displayed: