User manual

Installation and User Manual ADPRO FastTx by Xtralis
10 Doc 11949_06
2.7.4 Configuring the PC for Serial Connection
Note: The following procedure is only required if you have a null modem cable and do not
intend to use the crossover ethernet cable to connect to the ADPRO FastTx. (Refer
to Null-modem Cable Wiring on page 15 for wiring details for the null modem cable).
The serial comms (COM) port on the PC must be configured for operation as follows:
1. Select Control Panel / System / Hardware tab.
Figure 6: System Properties
2. Select Device Manager and expand the Ports (COM & LPT) selection.
Figure 7: Device Manager