User manual

ADPRO FastTx by Xtralis Installation and User Manual
Doc 11949_06 7
To complete ADPRO FastTx installation, you may need:
• Null modem cable
• Camera and coax cable
• External alarm switches or other devices
• ISDN Terminal Adaptor or Modem
• PC or Laptop running Microsoft
®
Windows
®
2000 Professional or Windows
®
XP
Professional, with an Ethernet Port or a serial port and a DVD drive.
2.5 Mounting the ADPRO FastTx
2.5.1 Rack Mounting
The ADPRO FastTx models are housed in a 3 U high chassis for mounting in a 19" rack with a
layout as shown in the following figure. To ensure long term electronic equipment reliability, it is
advisable to:
• mount the unit clear of other equipment that can dissipate large amounts of heat,
• ensure adequate air flow (either convective or forced) between the unit and its
surroundings, and
• ensure that the fan opening on the rear panel is not blocked by other equipment.
Figure 3: ADPRO FastTx Front Panel for 19 inch Rack Mount Models
2.6 Setting the Video Standard
ADPRO FastTx can be set to operate using either PAL (CCIR) or NTSC (RS170) video
standards. Once a standard has been selected, all video inputs and the monitor output
(composite video) will be configured to use the same standard.
To set the required video standard, use the Configuration DIP switch on the rear panel.
Configuration Switch # 10 ON = NTSC
OFF = PAL
Note: To be configured correctly, this switch must be set before power on.